Kronos CNC Router Upgrades

Today Micah installed a new spoiler board with rails for clamping on the Kronos. Please be aware of your cut depths and travel moves to avoid hitting the rails and clamps. If you use clamps on the outer rails you’ll need to block up the clamp as shown on the right side. There is 48″ between the outer rails so you can clamp down a full sheet of plywood.

IMG_3055

Here’s our new cyclone dust collector! We still need to run ducting but it’s a great air purifier as it’s set up now 😉

Once it’s hooked up it will automatically turn on when the CNC or table saw are used. We will also run ducting to the chop saw but it will need to be manually switched on for that as turning it on and off for quick cuts will not work.